بررسی تاثیر عملیات حرارتی پس از جوشکاری بر خواص خوردگی  فصل مشترک اتصال انفجاری ورقهای برنز-فولاد ساده کربن

raisipour chehrazi, farshad; khanzadeh, mohammadreza; razazi, mohammad; bakhtiari, hamid

Volume 17, Issue 2 (9-2022) مواد پرانرژی 2022, 17(2): 91-100 | Back to browse issues page

‎ 20.1001.1.17353629.1401.17.2.2.9

Mendeley

Zotero

RefWorks

raisipour chehrazi F, khanzadeh M, razazi M, bakhtiari H. بررسی تاثیر عملیات حرارتی پس از جوشکاری بر خواص خوردگی فصل مشترک اتصال انفجاری ورقهای برنز-فولاد ساده کربن. مواد پرانرژی 2022; 17 (2) : 2
URL: http://isaem.ir/article-1-1426-en.html

بررسی تاثیر عملیات حرارتی پس از جوشکاری بر خواص خوردگی فصل مشترک اتصال انفجاری ورقهای برنز-فولاد ساده کربن

Farshad Raisipour chehrazi

, Mohammadreza Khanzadeh ^*

, Mohammad Razazi

, Hamid Bakhtiari

, khanzade@gmail.com

Abstract: (706 Views)

In the current research, the microstructural changes and corrosion behavior of two-layer Steel/Bronze sheets were investigated after the heat treatment of the explosive welding process. The heat treatment was performed at 600ºC for 16 hr. Dynamic potential polarization, electrochemical impedance spectroscopy, optical microscopy, and scanning electron microscopy analyses were used. Based on of the electrochemical impedance analysis, the highest polarization resistance, which was equal to 30160 Ω cm² and followed by the third sample having a resistance of 20720 Ω cm², was seen in a sample with a stand-off distance of 1.5 mm and an explosive thickness of 20 mm, but the lowest polarization resistance was seen in a sample with a stand-off distance of 2 mm and an explosive thickness of 45 mm. According to the EDS analysis, from a common interface sample with a stand-off distance of 1.5 mm and an explosive thickness of 20 mm, it was concluded that the interface of steel and bronze is noble due to the high concentration of copper in the interface, therefore the corrosion speed is less than other samples. The metallographic results showed a decrease in the amplitude of the waves because of the decreasing the thickness of the explosive charge. Moreover, in the heat treatment samples, the grain size of ferrite grains has a dramatic growth, so, due to recrystallization after the heat treatment, the grains with an elongated appearance are not seen next to the interface.

Article number: 2

Keywords: Explosive welding, stand-off distance, severe plastic deformation, vortex.

Full-Text [PDF 4215 kb] (46 Downloads)

Type of Study: Research | Subject: جوشکاري انفجاري شکل دهي انفجاری
Published: 2023/03/21